Shenzhen ECON Technology Co.,Ltd
call us on: +8613620961024
Home > News > Content

Notes For Servo Driver Connection

Shenzhen ECON Technology Co.,Ltd | Updated: Sep 16, 2017

      Notes for Servo Drive Cable Connection

8 precautions of servo drive ground wiring are as following:

① The correct shield ground wiring,is located at the reference electric point inside its circuit, which depends on the noise source and the reception whether ground at the same time,or float.

② Make sure that the shield is grounded at the same point so that the ground current does not flow through the shield.

③ to avoid a variety of ways to connect the earth to produce ground loop is susceptible to noise,then  generate current at different reference points.

④ In the case where there is no isolation between the AC power supply and the driver DC bus,can not connect the non-isolated port of the DC bus or non-isolated signal to the ground,it will lead to equipment damage and personal injury and so on.

⑤ Avoid the servo drive connected to the external power supply, will directly affect the controller and servo drive work.

⑥ Exchange public voltage is not for the earth,between the DC bus and the earth may have very high voltage, prohibit straight connect

to ground.

⑦ in the servo system, the public and the earth must be connected at the signal side.

⑧ In order to keep the command reference voltage constant, the signal ground of the servo driver is connected to the signal ground of the controller.

Contact Us

Shenzhen ECON Technology Co.,Ltd

Add: 2F, Building B, Jintai Industrial Park, Hangcheng Avenue, Gushu Village, Xixiang Street, Bao'an Area, Shenzhen, Guangdong, China

Tel: +86 136 2096 1024


Copyright © Shenzhen ECON Technology Co.,Ltd